Cold and Flu – Heating Specialist

SW Van Racking produced a solution by first lining out the whole rear with 6mm & 9mm Plywood. Then a false floor was constructed so that the customer could slide flat sheets of metal underneath and a further under floor compartment for the off cuts. The van was then racked out using 12mm hardwood faced plywood to the customer’s specification.

Read More

Carpet Fitter

SW Van Racking came up with a bespoke design which was made to measure using 12mm MDF and 50mm x 50mm framework. The solution was more complex due to the customers requirement for separate cubby holes to accommodate carpet grippers, thresholds etc.

Read More

Plaster’s Van

On this occasion the customer wanted a simple solution, so a two tier racking system was built from 12mm MDF on a 50mm x 50mm framework.

The Customer was happy with the solution as it now prevented his tools from rolling around whilst driving.

Read More

Somerset Weddings & Disco

This customer was fed up putting everything on top of each other and his equipment would slide all over the place whilst driving. SW Van Racking came up with a solution by racking one side using 12mm MDF on a 50mm x 50mm frame for strength. Then an MDF partition was fitted to stop the larger items sliding around.

Read More

Nicholls and Sons Plumbing

SW Van Racking built a bespoke racking system from 12mm MDF on a 50mm x 50mm frame.
The frame work was scribed to the van and staggered per the customer’s requirements. The deeper section designed for their tools and the shallower section for plumbing fittings.
Once again a very happy customer

Read More

Atlas Remapping – Vehicle services

SW Van Racking built a bespoke desk and racking for this customer. A right angle desk was constructed from 18mm MDF. The desk was fully scribed to the profile of the Van. The front edge was routed to give a nice bullnose finish. Racking was then made above the wheel arch for client’s tools.

Read More

Exmoor Logs

The solution for this customer involved making a folding plywood box to fit on the rear of the vehicle. The box was constructed from 18mm hardwood faced plywood. This solution enabled the customer to fold up the box when not required.
Another satisfied customer

Read More

NEED SOME HELP? CONTACT US! swcarpentry@rocketmail.com 07887 963865